!
You can find the Aero Precision 5.56 PRO Bolt Carrier Group Black Nitride here Fast $9.95 shipping! Orders over $200 ship for free!
The Aero Precision 5.56 PRO Bolt Carrier Group was built from the ground up to meet the demands of the most extreme conditions. Each component and manufacturing process of the PRO 5.56 Bolt Carrier Group was deliberately chosen to increase the reliable service life of the bolt carrier group and its components.
The bolt is machined from 9310 steel, a proprietary flash nitride process was chosen to ensure proper heat treatment on the bolt. When properly heat treated, 9310 steel provides superior strength and durability when compared to C158. The cam pin channel is counter bored, eliminating the need for swaging. Swaging is the industry standard, however this process creates more stress on the bolt during manufacturing by displacing material rather than cutting it to the proper dimension from the start. The bolt is also shot peened and MPI tested.
The cam pin features an engraved indexing mark on one side of the cam pin face; a concept that has been popularized by Chad Albrecht at School of the American Rifle. Cam pins traditionally wear more heavily on one side and when installed inconsistently can create excessive wear over time. When the cam pin becomes "loose" this can create excessive wear on the bolt itself shortening overall life. The indexing mark allows for consistent installation during maintenance which in turn reduces wear on not only the cam pin but the bolt over time to help extend overall service life. The cam pin is machined from 4140 steel and has a nitride finish.
The extractor features a phosphate finish. The extractor is one of the few places where it is beneficial to have a "rougher" finish as it allows for more positive engagement with the case when pulling it out of the chamber. The extractor is machined from 4140 steel that is heat treated and shot peened.
The PRO Bolt Carrier Group is machined from 8620 steel, utilizes a M16 cut carrier and features a nitride finish. Internal critical surfaces are precision ground to exacting tolerances to ensure optimal gas efficiency. The same machining standards are used for the carrier rails providing a super smooth fit and function from the start.
The gas key is machined from hardened 4140 steel and has a nitride finish. The gas key is properly staked per mil-spec and torqued to spec with grade 8 hex fasteners. The ejector is machined from S7 tool steel and the firing pin is ground from 8640 steel and has a nitride finish.
Finish: Black Nitride
Caliber: 5.56
Weight: 11.4oz
Premium Vendor Details
Phone
Website
Location
Shipping
