These Pistols in a word are awesome. Here is what Wiki says about them;

The grip of this pistol features a built-in cocking lever located at the front of the grip. Before the pistol can be fired, this lever must be squeezed; thus this lever acts as a safety. The pistol is striker fired.[8] Squeezing the cocking lever with a force of 70 N (15.7 lbf) cocks the firing pin. Once fully depressed, only 2 pounds of force are required to keep the weapon cocked. The weapon is then fired by pressing the single stage trigger rated at approximately 20 N (4.5 lbf) As long as the lever is depressed, the weapon fires like any other semi-automatic pistol. If the lever is released, the weapon is immediately de-cocked and rendered safe. This method of operation dispensed the need for a manual safety selector while providing safety for the user carrying the pistol with a chambered round, and increased the speed with which the pistol could be deployed and fired. The trigger and firing mechanism's method of operation (and the unique slide catch) were protected by U.S. Patent 4,132,023, issued on January 2, 1979.[9]

The P7 is fed from a single-stack box magazine with a capacity of 8 rounds,[10] which is held inside the firearm's frame with a release located at the heel of the grip. After the last round has been fired, the slide will remain open thanks to a slide catch that can be released by pulling the slide further back or pressing the squeeze cocker.

The firearm uses a fixed, polygonal rifled barrel (hexagonal with a 250 mm twist rate) and a fixed notched iron sight with contrast dots that enable shooting in low-level lighting conditions. The pistol is completely ambidextrous and two-handed use is enhanced through the use of a profiled and enlarged trigger guard.[1]

Between 1982–1983 the P7 received several modifications, mainly to address American market demand and shooter preferences. These modifications resulted in the P7M8 model. A new magazine release lever (available on both sides of the frame) was installed just beneath the trigger guard, which forced designers to modify both the pistol's frame and magazine.[11] The trigger guard was equipped with a synthetic heat shield that protects the shooter from excessive heating and a lanyard attachment loop was added in place of the previous magazine heel release.
This gun is in 95% condition or better. Comes with numbered factory box and two mags .
MN buyer needs MN state ID and permit.
Buyer residing outside of MN pays $30 shipping to local FFL for transfer.